Filter
Top Products
6.4.2.1 Installation / Settings / TV Settings
The TV Settings screen contains two options: TV
Screen Format and Display Format.
The TV Screen Format allows you to adapt your
receiver output to the aspect ratio of your TV set (4:3 or
16:9).
You can also modify the Display Format value to adapt
the way the video is transformed in case the broadcast
aspect ratio is different from your TV aspect ratio.
TV Settings Screen
In such a case:
6.4.2.2 Installation / Settings / System Settings
The System Settings screen contains some of the
configuration parameters you may change.
Video Standard
This option is preconfigured depending on the Country
selection. There are two possible standards: PAL and
SECAM.
TV SCART Output, VCR SCART Output
Select the appropriate format of the output signals.
Note: to get the best picture quality and sharpness set the "TV
SCART output" option to "RGB".
System Settings Screen
Dolby Digital
Default Dolby Digital setting is No. Do not modify this
setting if your audio receiver supports PCM only (Stereo
digital). If your audio receiver supports AC3 (multisound
system Dolby Digital 5.1), set Dolby Digital to Yes.
You will find detailed info concerning: the Easy
Recording, Recording Type and Device settings in the
Advanced Settings section later in this manual
(see chapter 7).
Default Volume level
This option is used to set the sound level at wake-up
from standby. It is recommended to set it close to the
maximum value.
English
CHANGE THE SETTING OF YOUR RECEIVER 29
Aspect
TV screen format = 4:3 TV screen format = 16:9
Display
ratio
format
broadcast format = 16:9 broadcast format = 4:3
Letter-box full picture with black bars at the full picture with black bars on the left
top and bottom and right
Pan-Scan picture cut-off on the left and right picture cut-off at the top and bottom
Full screen full picture squeezed to fit full picture squeezed to fit
6610_A5_GB.qxd 01/09/2004 12:58 Page 29