Filter
Top Products
8 Programming the Remote Control for your
STB, TV, Video Recorder, DVD and Tuner -
Amplifier
8.1 Setting up your remote control
By default at power up, for instance at first installation or at battery replacememt, your remote
control is preset to control your terrestrial receiver as well as most of the Philips audio/video
appliances.
If you have other brands of appliances, or if the presets do not control your Philips appliance,
please follow the procedure here below.
Note: some of the functions described in the next pages may not be available or have the same behaviour
for all brand of the same appliances.
1 Press the MODE button to select the type of appliance you want to set up (TV, VCR, DVD or
Amp/Tuner). Pressing the MODE button once will remind you of the MODE you are in through
green light indicators: left for STB, middle for TV, right for VCR, left/middle for DVD, middle/right
for Amp/Tuner.
To set the MODE, press the MODE button several times until the desired mode is signaled by
the light(s). The sequence is: STB ➔ TV ➔ VCR ➔ DVD ➔ Amp/Tuner. At every key press, lights
blink to indicate in which MODE you are in.
2 Press digits 1 and 3 simultaneously until the lights corresponding to the selected mode blink twice
and remain on.
3 Enter the 4 digit code .The lights corresponding to the selected mode blink once at each digit
entry. You will find a list of codes at the end of this manual. (If several codes are possible, go
through this procedure with the 1st code and try your remote control. If you are not successful,
repeat the procedure with the second code, and so on).
4 If a valid 4-digit code has been entered, the lights will switch off and blink twice. If not, go back to
step 1. Pressing any key other than digit keys and standby button will automatically exit this
procedure.
We advice you to fill in the table below to remind your personal remote control settings, this will
be helpful the day you have to replace the remote control batteries (see NOTE 2 below).
English
PROGRAMMING THE REMOTE CONTROL 35
Philips Brand Your appliance Your code
factory setting brand / type setting
TV set 0666
Video Recorder 1608
DVD player / Recorder 0566
Amplifier / Tuner 1316 (Philips tuner)
STB (Your Satellite Receiver) 0038 (Device 1)
Volume control
(see chapters 4.2.2.1 and 4.2.2.2)
6610_A5_GB.qxd 01/09/2004 12:58 Page 35