Filter
Top Products
6.4.2.5 Installation / Settings / Decoder Upgrade
Settings
Select Upgrade Settings from the Settings submenu.
In this screen you can change the way your decoder is
upgraded.
If you set Auto Upgrade to Yes, your decoder will
automatically initiate the upgrade procedure when
available. Otherwise you will be asked for permission to
initiate the procedure.
If you want to be prompted to check for new upgrades
every time you switch your decoder on, the Upgrade
Check After Power On should be set to Yes.
Decoder Upgrade Settings
You can also set the exact time and frequency of checks
for new upgrades in Upgrade Check in Operate
Mode. Note that your decoder must be in running mode
in order to check for upgrade at the specified time.
6.4.2.6 Installation / Settings / Country
Selecting Country item allows you to change any presets
for a particular country. If you change the country and
confirm your choice, your decoder will be configured to
work in the country you selected.
Note that changing the country will initiate the channel
search and you will lose your current channel list.
Select Country
6.4.3 Installation / Signal Meter
Selecting the Signal Meter from the Installation
submenu brings up the Signal Meter screen. This screen
displays the signal strength/level as well as the quality
value of the signal broadcast at the specified frequency.
Signal Meter
English
CHANGE THE SETTING OF YOUR RECEIVER 31
6610_A5_GB.qxd 01/09/2004 12:58 Page 31