Filter
Top Products
98
PROBLEM SOLUTION
I cannot playback (Super)
Video CDs
bIt is possible that this (Super) Video CD contains a menu and the 'PBC' is switched off. You
can see this in status field 'PBC OFF'. To activate this function, proceed as follows:
1 Press SYSTEM-MENU while the (Super) Video-CD is inserted.
2 Select '
A
' using D or C .
3 Select line '
s
(Disc features)' using CH- B or ACH+ and confirm with C .
4 Select 'On' in line 'PBC' using CH- B or ACH+ .
5 Confirm with OK and end with SYSTEM-MENU .
Poor playback on DVD
Recorder (distorted
picture/distorted sound)
bYour TV is not properly adjusted.
bThe disc is dirty: Clean the disc.
bSometimes the picture may be temporarily distorted. This is not a defect of your DVD
Recorder.
No recording possible. bThe TV channel you want to record is not stored or you selected the wrong program
number: Check TV channels stored.
bDisc is write-protected (cannot be recorded on): Remove write-protection or change the disc.
For more information, please see 'Preventing accidental erasing of discs' on the 'Manual
Recording'.
bA finalized DVD+R has been inserted. Change disc.
Programmed recording
does not work:
bYou have set the wrong time or date: Check time/date.
bYou have not set the TIMER properly: Check the programmed recordings (TIMER block).
bA locked disc was inserted: Remove disc lock.
bA finalized DVD+R has been inserted. Change disc.
bCabelbox (if available) switched off: Switch it on
bIR-Blaster not connected: Connect the IR-Blaster andset up the GUIDE Plus+
®
system with
the cable box. (Chapter 'The GUIDE Plus+
®
system, section 'Setting up the GUIDE Plus+
®
system').
Missing or wrong TV
channels
bWrong cable connection selected
bWrong channel line up selected.
'DEMO' appears if I press
the GUIDE/TV button.
bThe Demo Pin from the G-LINK jack on the backside of the DVD Recorder was not
removed.
1 Disconnect the DVD Recorder from the power outlet.
2 Remove the DEMO pin from the G-LINK jack on the backside of the DVD
Recorder
3 Re-connect the Recorder to the power supply.
The cable box do not
always react to the IR
Blaster
bThe Infrared (IR) Remote control signal interfere with the IR signal of the IR Blaster
Put the IR Blaster closer to the front of the cable box.
In the GUIDE Plus+
®
'LISTINGS' screen, I see too
many or too less TV
Channels
bThe number of TV channels depends on the setting in the GUIDE Plus+
®
sytem settings.
If you have a Cable Box installed (Cable Box 'YES'), then you should switch on the available
channels (Channels above 125).
bIf you have no Cable Box installed (Cable Box 'NO'), then you should switch off the channels
which are not available.
Before you call technical support