Filter
Top Products
32
Manually setting the time & date
If the time is incorrect, this could be due to a weak or disrupted TV signal. If this is the case,
switch off the automatic function.
Attention!
If data from the GUIDE PLus+
®
system were loaded, you can not change the clock/date because
this information was taken from the GUIDE Plus+
®
system. Therefore you can not select this
function.
1
Press SYSTEM-MENU on the remote control. The menu bar
will appear.
2
Select '
A
' using D or C .
3
Select line 'Installation' using CH- B or ACH+ and confirm
with C .
4
Select line 'Time/Date' using CH- B or ACH+ and confirm
with C .
a'Not allowed' will appear on the TV screen
b The time/date will automatically be taken from the EPG information.
Therefore you can not set the time/date manually.
Problem
5
Select 'Manual' with CH- B or ACH+ .
6
Confirm with OK .
Time/Date
Manual
Time 09:02
AM/PM AM
Year 2003
Month 01
Date 01
Daylight Saving Off
To exit press
SYSTEM MENU
7
Change the time in line 'Time' using the number buttons 0..9 on
your remote control.
8
Check 'AM/PM', 'Year', 'Month', and 'Date' in the same way.
To select between the fields, use CH- B or ACH+ .
Change the information with D , C or the number buttons
0..9 .
9
Select one of the following settings in line 'Daylight Saving':
'On': The time set corresponds to the summer time (summer
time is on)
'Off': The time set corresponds to the winter time (summer time
is off)
10
When all settings are correct, confirm with OK .
11
To end, press SYSTEM-MENU .
If the setting has been confirmed with OK the automatic system is disabled.
Installing your DVD Recorder