Filter
Top Products
Boat Remote User’s Manual
18
Connecting the Power Supply
There are two entry points for wiring into the enclosure of the Boat
Remote. They are: a slot on the back of the enclosure below the
access panel and a perforated “punch out” on the lower side of the
enclosure. For a neat and clean installation, run your wires through
the wall and have them enter the enclosure through the slot in the
access panel area. Otherwise, remove the “punch out” and run the
wires through this entry point. To remove the “punch out”, take off the
access panel and press on the outside of the enclosure, over the
“punch out”, with your thumbs until the plastic is removed.
The power transformer has three terminals that must connect to the
Boat Remote. Use the 3-conductor cable included with the unit and
start with the Boat Remote terminals. Attach the red and black wires
of the cable to the 14VAC terminals on the Boat Remote. Refer to
Fig. 2.2. Connect the uninsulated wire to the EG (Earth Ground)
terminal. On the Transformer, connect the red and black wires to the
end screws and connect the uninsulated wire to the center screw.
Plug the transformer into an electrical outlet not controlled by a wall
switch.
Fig. 2.2 Connecting Power and Telephone Service