Filter
Top Products
Boat Remote User’s Manual
42
INPUTS
In preparing the Boat Remote to sense an alert condition several
parameters must be configured for each input. The following
paragraphs describe these important parameters.
Input Mode: Active, Off, Status Only
An input configured in the Active Mode will be enabled to dial out for
alarms, show its status in the scrolling display, and also have its
status reported during call-in.
An input configured in the Off Mode will be totally disabled. It will not
dial out for alarms, show its status in the scrolling display, nor be
reported during a remote status report.
An input configured in the Status-Only Mode will not dial out, but its
status will show in the scrolling display and it will be reported during
a status report.
Input Dial Out Phone Selection
The Input Dial Out Phone Selection is the list of phone numbers that
will be called if an alarm occurs for that input. This list may include
one or more of the phone numbers programmed by you for the Dial
Out Phone Numbers (1-8). Boat Remote will dial the numbers
sequentially (1-8), regardless of what order you enter them in the
Input Dial Out Phone Selection.
Recognition Time (not for Bilge #1 & #2)
This is the programmable waiting period to determine if an alert
condition has persisted long enough to be considered a valid alarm.
If the sensor returns to normal within the Recognition Time, then no
alarm will occur.
In addition to these parameters each input requires levels, time
constraints, or other conditions for you to set. This section of the
manual along with the local display will guide you through program-
ming. Please read through this section before you begin to program.
Consider the choices that follow for each input and how they apply to
your needs.
To keep previous settings scroll to the next parameter with the down
arrow key. To clear an input phone selection press
ENTER before
pressing any numbers for that phone selection, while in an Input
menu. When changing a parameter press ENTER when your choice
appears on the display. Press the down arrow one extra time, once
you have reached the end of an input menu, to reach the idle
screen.