Filter
Top Products
Boat Remote User’s Manual
70
2) The unit is operating in Away Mode, so after 30 seconds it checks
the dialout selection list for the AC Power input. It then dials the first
number on the list (phone #1, Marina office, 555-1111).
3) The Marina office is closed at night so the unit receives no answer
and hangs up.
4) Boat Remote waits 2 minutes (programmed Intercall Delay time)
then dials the Marina manager’s beeper (phone #2).
5) The phone is answered.
6) The unit leaves its telephone number (555-2628) on the beeper
display.
7) The manager’s beeper goes off and he calls the displayed
number.
Acknowledgment
1) After 5 rings, Boat Remote answers the incoming call and says:
“Hello, this is (Boat Remote ID Message).
The AC Power is off.
Indicate you have received warning message.”
2) The Marina manager enters the ‘555’ acknowledgment code and
Boat Remote says:
“Alarm acknowledged”
3) The unit will then hang up. The alarm has been acknowledged
and the dialout sequence stopped.
NOTE: Boat Remote will not dial out again for an AC Power failure
unless the power is restored and then fails a second time.
EXAMPLE 4: (On-Board Mode: local acknowledgment)
Alarm Recognition
While you have your boat out for a cruise, an electrical system
problem develops and your boat’s batteries slowly begin to dis-
charge. The battery voltage drops below the programmed low limit of
10.0 volts. The condition continues for 5 minutes (the programmed
alarm recognition time) and the Battery input is set to “Active” so
Boat Remote enters the Alarm Notification sequence.
Alarm Notification
1) Boat Remote repeats the message “The battery voltage is low”