The Initial Setup menu
14
106
En
Manual CH Setting Next Screen Proceed to the next screen if you need to adjust any
of the settings made by auto tuning. Select your
country, then proceed to the manual channel setting
screen:
• Change channel presets using the
PREV/
NEXT buttons.
• To skip the displayed channel (because there is no
station assigned to that channel), change the Skip
setting to On.
• To manually fine tune the channel, change the AFT
setting to Off then adjust the Level setting.
VCR Plus+ CH
Setting
Next Screen Proceed to the next screen to assign channel
numbers to the guide channels as necessary. Look in
your TV guide to see which channel numbers should
be assigned to which guide channels. Press ENTER
when your done to leave this screen.
Video In/Out
Input Colour
System
Next Screen Proceed to the next screen to set the input colour
system for the external input and the built-in TV
tuner. Use the
CH +/– buttons to change the preset.
On the default Auto setting the recorder can
generally correctly detect whether the input signal is
3.58 NTSC or PAL-M, but in some cases you may
have to set it manually if the picture is displayed
incorrectly.
If the Input Line System setting is 625 System then
the Input Colour System is automatically set to
PAL-N.
See also About the input colour system on page 115 for more information on this setting.
Component Video
Out
Interlace • Select if your monitor/TV is not compatible with
progressive-scan video.
Progressive Select if your monitor/TV is progressive-scan
compatible. Check the operating instructions that
came with your monitor/TV if you’re not sure.
• If your TV is incompatible with progressive scan video and you select Progressive, you will not be able to see any
picture at all. In this case, press OPEN/CLOSE while holding down the (Stop) button on the front panel to
switch to Interlace (this also switches Screen Resolution on page 112 to the default setting).
• When the HDMI signal is output, no video is output from the COMPONENT VIDEO OUT.
NTSC on PAL TV On NTSC discs will play correctly on PAL-only TVs.
Off • Use if your TV is already NTSC-compatible.
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating
instructions that came with your TV. See also About NTSC on PAL TV on page 115 for related information.
Setting Options Explanation
14 Initial_Settings.fm 106 ページ 2007年4月9日 月曜日 午後1時58分