Connections
02
18
En
Connecting to a cable box or
satellite receiver (1)
If you are using a cable box or satellite
receiver with only a few scrambled channels,
follow the setup on this page
1
. If many or all
the channels are scrambled, we recommend
using the setup on the following page.
Using the setup on this page you can:
• Record unscrambled channels by
selecting them on this recorder.
• Record scrambled channels by selecting
them on the cable box/satellite receiver
and using the Auto Start Recording
feature (see
Automatic recording from a
satellite tuner
on page 47).
• Watch one channel while recording
another.
Important
• Do not connect this recorder ‘through’
your VCR, satellite receiver or cable box.
Always connect each component
directly to your TV or AV amp/receiver.
1 Connect RF antenna cables as shown.
This enables you to watch and record TV
channels.
2 Connect the AUDIO and VIDEO
OUTPUT jacks (1 or 2) on this recorder to
a set of audio/video inputs on your TV
using a set of A/V cables (as supplied).
This enables you to watch the output from
this recorder.
3 Connect the audio/video output of
your cable box/satellite receiver to the
INPUT 1 jacks on this recorder using a set
of A/V cables.
This enables you to record scrambled TV
channels.
Note
1 The diagram shows standard video connections, but you can alternatively use the S-video or component video
connections if they’re available.
AC IN
DIGITAL
AUDIO OUT
COAXIAL
HDMI OUT
CONTROL
IN
S-VIDEO
VIDEOAUDIO
L
R
ANTENNA
IN
OUT
S-VIDEO
VIDEOAUDIO
L
R
Y
P
B
P
R
OUTPUT 1
OUTPUT 2
COMPONENT VIDEO OUT
INPUT 1
/
AUTO START REC
INPUT 3
TV
Antenna/cable TV
wall outlet
Cable box/
Satellite receiver
ANTENNA
IN (RF IN)
ANTENNA
OUT
1
1
OUTPUT 1
INPUT 1/AUTO
START REC
1
2
3
To antenna input
To antenna input
From antenna output
To audio/video input
From audio/
video output
DVR650HS_TDR_EN.book 18 ページ 2007年4月9日 月曜日 午後12時10分