Additional information
125
En
15
• Repairing disc.
• Repairing the HDD.
During recording, the power was cut. This display
appears when the power is restored.
• Could not repair the disc.
The recorder was unable to repair the disc after a
power cut. The contents of the recording will be
lost.
• Overheating has stopped operation.
Press DISPLAY to clear message.
The internal temperature of the recorder has
exceeded the operating limit. If this message
reappears, please ask your nearest Pioneer-
authorized service center or your dealer to carry
out repairs.
• HDD optimization is recommended.
This can be done using Disc Setup.
The HDD should be optimized (basically, HDD
housekeeping) to maintain playback and recording
performance.
• Please perform HDD optimization.
This can be done using Disc Setup.
The HDD is in more urgent need of optimization in
order to maintain performance.
• The HDD has not been sufficiently
optimized. Please optimize again.
If this message appears repeatedly after
optimizing the HDD it is likely that there is not
enough free space on the HDD for optimization to
complete properly. Please erase some titles from
the HDD and optimize again.
• An error occurred. Please consult the
service center. Note that contents on
the HDD may be erased when servicing
this unit.
This message is displayed when information from
the HDD cannot be read. The HDD may be
damaged or broken. Please ask your nearest
Pioneer-authorized service center or your dealer to
carry out repairs.
• The Hard Disk Drive info is incorrect.
Use the Disc Setup menu to reinitialize.
As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 101) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.
• This signal’s TV system is different
from the recorder’s setting.
The TV system (PAL, NTSC, etc.) of the current
channel is different from the TV system settings of
this recorder.
• Recording failed due to a TV system
mismatch. Press DISPLAY to clear
message.
The timer recording failed because the TV system
of the channel set for recording was different from
the setting of the recorder.
• Playback has stopped because the TV
system is different than the recording.
During recording or timer recording standby, the
TV System (PAL, NTSC, etc.) of the playback video
changed, causing playback to stop automatically.
Message
Explanation/Action
DVR650HS_TDR_EN.book 125 ページ 2007年4月9日 月曜日 午後12時10分