Filter
Top Products
The Initial Setup menu
14
116
En
Chapter 14
The Initial Setup menu
Using the Initial Setup menu
The Initial Setup menu is where you can set various recorder options for sound, picture,
language and so on.
Some settings can only be changed when the recorder is stopped. During playback and
recording these settings are grayed out in the Initial Setup menu.
Except for the Setup Navigator, menu screens are exited automatically after 20 minutes of
inactivity.
• Press HOME MENU and select ‘Initial Setup’.
In the table below, the default option is marked with a •.
Setting Options Explanation
Basic
Clock Setting Auto
Set the channel that broadcasts a clock signal and
the clock will be set automatically.
Manual •
If there is no channel that broadcasts a clock signal
in your area, you can set the time and date manually.
The clock must be set in order to use timer recording.
Input Line System 525 System
Use for NTSC or PAL-60 recording from an external
input.
625 System •
Use for standard PAL or SECAM recording.
See also About the input line system on page 127 for more information on this setting.
Power Save Mode 1
Only signals arriving at the antenna input are passed
through to the antenna output when the recorder is
in standby.
Mode 2
No input signals are passed through to the outputs
when the recorder is in standby.
Off •
When the recorder is in standby, all signals arriving
at the SCART and antenna inputs are passed along
to the outputs.
DVR540H_WV_EN.book 116 ページ ２００６年２月１６日 木曜日 午後４時３４分