Filter
Top Products
Using the GUIDE Plus+® electronic program guide
05
50
En
the on-screen question about whether
the receiver has changed to a certain
channel, the GUIDE Plus+ system has
sent a different code). Try all the different
codes until your GUIDE Plus+ system
can control your external receiver
correctly. If you have no success, try to
receive new codes overnight.
•I used to receive data through my
terrestrial antenna or analog cable
without a set-top box. Now, I have
“upgraded” to a satellite system or to
digital cable with external receiver. What
should I do to receive data for the GUIDE
Plus+ system?
You can try to receive your host channel
through your new reception method. If
you have problems to receive data we
recommend that you keep your analog
terrestrial or cable connection only to
receive data this way. It is important that
you identify your host channel correctly
in the Editor Area.
• After I performed the initial set-up I found
that the line-up for all the channels
received via the external set top box is
incorrect. How do I correct this?
You can change the line-up in the editor
according to your preferences. Access
the Editor Area. Select the channels that
you would like to change. Change the
source and preset number according to
your preferences.
•I performed the set-up but after many
hours I still have a blank EPG what is
going wrong?
There are several possibilities:
– Connections are wrong. See
Connecting up
on page 14 to double
check everything.
– The initial setup of GUIDE Plus+ was
completed incorrectly. Try setting it up
again (see
Setting up the GUIDE Plus+®
system
on page 32).
– Your cabling and setup is OK, but the
recorder has not been connected for
enough time to receive the TV listings
data. Leave the recorder in standby
overnight.
– For external receiver users only: The
connections and setup are OK, but the
external receiver was not tuned to the
correct host channel. Check the list of
host channels (see step 5 of
Setting up
the GUIDE Plus+® system
on page 32)
and leave the recorder in standby and
the external receiver on overnight tuned
to the correct host channel.
– You live in a country/region where the
GUIDE Plus+ system is not yet available.
Check the list of countries to see if you
are in a region that is supported.
•I used the One-Button-Record feature (red
Action button) to set a recording, but I
recorded the wrong channel.
If the channel to be recorded is received
via the external receiver first make sure
that the external receiver was left
switched on. Next, in the Editor Area,
make sure that the channel to be
recorded is correctly set: Access the
Editor Area. Check the source and
program number of the channel that you
wanted to record. Change the source
and preset numbers if incorrect.
If you are recording from the recorder’s
internal tuner (the
Tuner
setting), make
sure that the program number is the
same as the preset number set on this
recorder. If they are different, go to the
Editor Area and change the program
number to match the recorder’s preset
number.
DVR540H_WV_EN.book 50 ページ ２００６年２月１６日 木曜日 午後４時３４分