Pioneer DVR-540H-S DVD Recorder User Manual


 
The Initial Setup menu
14
119
En
Component Video
Out
Interlace • Select if your monitor/TV is not compatible with pro-
gressive-scan video.
Progressive Select if your monitor/TV is progressive-scan compat-
ible. Check the operating instructions that came with
your monitor/TV if you’re not sure.
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than RGB.
AV1 Out Video • Sets the AV1(RGB)-TV SCART output to standard
composite video (compatible with all TVs).
S-Video Sets the AV1(RGB)-TV SCART output to S-video.
Recommended if you are using a long SCART cable.
RGB Sets the AV1(RGB)-TV SCART output to RGB. Good
quality but check your TV for compatibility. Note that
on this setting signals from the built-in tuner and
from external inputs is not output when the recorder
is in TV mode.
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case
either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on
page 141).
The Component Video Out setting (see above) has no effect when AV1 Out is set to RGB.
AV2/L1 In Video • Sets the AV2 (INPUT 1/DECODER) SCART input to
standard composite video.
S-Video Sets the AV2 (INPUT 1/DECODER) SCART input to
S-video.
RGB Sets the AV2 (INPUT 1/DECODER) SCART input to
RGB.
Decoder Use this setting if you connected a decoder to the
AV2 (INPUT 1/DECODER) SCART connector. For
scrambled channels, make sure that the channel
Decoder setting is set to On. (See Manual CH Setting
page 118.)
When the Input Line System is set to 525 System, RGB cannot be selected.
Even when set to RGB. depending on the connected device, the input signal may be composite video.
Setting Options Explanation
14 Initial_Settings.fm 119 ページ 2006年2月17日 金曜日 午前11時37分