Filter
Top Products
Copying and backup
09
96
En
• Low resolution (
SEP
through
LP
modes
1
)
widescreen material can’t be copied to a
Video mode disc. Use a VR mode
DVD-R/-RW or DVD-RAM disc for this
type of material.
• When HDD Recording Format is set to
Video Mode Off, titles recorded in
LP
/
MN9
to
MN15
modes cannot be high-
speed copied to a Video mode disc.
Please use a VR mode DVD-R/-RW or
DVD-RAM.
• Recordings of bilingual broadcasts
cannot be high-speed copied to a Video
mode DVD. Please use a VR mode DVD-
R/-RW or DVD-RAM.
• Titles over 8 hours cannot be copied to
single-layer DVD+R/+RW discs using
One Touch Copy. Use DVD+R DL discs
for titles over 8 hours.
• Titles recorded in
MN1
to
MN6
,
SEP
,
SLP
or
EP
mode cannot be copied to DVD+R/
+RW using One Touch Copy.
Copying to the HDD
• The maximum title length for copying is
12 hours.
• Title name and chapter markers are also
copied, except when copying from a
finalized Video mode disc.
• Thumbnail picture markers and chapter
markers for the Disc Navigator are
copied, but their position in the copy
may be slightly changed from the
original.
• If some part of the title being copied is
copy-protected, copying will start, but
the copy-protected portions will not be
copied.
Using Copy Lists
* See also
Copyright
on page 95.
At its simplest, a Copy List is just a list of
HDD or DVD titles that you want to copy.
When copying HDD titles to DVD, you can,
however, edit the titles in your copy list,
erasing chapters you don’t need, or re-
naming titles, for example. Edits you make to
titles in the Copy List do not affect the actual
video content; only the ‘virtual’ content of the
Copy List. So you can freely erase and modify
anything in your Copy List safe in the
knowledge that the actual content is not
being altered.
Copying from HDD to DVD
Important
• The recorder can only store one Copy List
at a time.
• The Copy List is erased if the Input Line
System setting is changed (see
Additional information about the TV
system settings
on page 127).
• Resetting the recorder to its factory
settings (see
Resetting the recorder
on
page 141) will erase the Copy List.
1 Load a recordable DVD.
• It is possible to complete the following
steps without having a recordable DVD
loaded (or having an uninitialized DVD
loaded); however, the steps are slightly
different.
• If you want to use a DVD-RW (VR mode)
disc for the copy, make sure it is
initialized before you start.
Note
1 In manual recording mode these equate to
MN1
to
MN15
(Video Mode Off) or
MN1
to
MN8
(Video Mode On).
DVR540H_WV_EN.book 96 ページ ２００６年２月１６日 木曜日 午後４時３４分