Filter
Top Products
11
En
Safety Precautions
02
English
Installation Precautions
Observe the following precautions when installing the panel using optional mounting methods such as the bracket.
When using the optional brackets or equivalent items
• Ask your dealer to perform the installation.
• Use only the supplied bolts.
• For details, see the instruction manual that comes with the optional bracket (or equivalent mounting item).
When using other items
• Consult your dealer.
• The following six mounting holes can be used for the installation:
CAUTION
• Use at least four mounting holes symmetrical to the vertical and horizontal median lines.
• Use M8 screws, which go 12 mm to 18 mm (0.5 inches to 0.7 inches) in depth from the mounting surface of the Plasma Display.
See the side view above.
• Be careful not to block rear vents on the Plasma Display.
• Install the Plasma Display on a flat surface to avoid warping the glass.
• The diagrams above show the location of standard mounting screw holes. Holes other than those shown above are for specific
mounting methods and should not be used unless a mounting option’s instructions require their use.
NOTE
• Use the optional PIONEER mounting products whenever possible.
• PIONEER shall not be liable for any personal injury or property damage that results from using mounting items other than the
optional PIONEER products.
Side view
Mounting surface
Plasma
Display
Mounting
bracket (or
equivalent item)
M8 screw
12 mm to 18 mm
(0.5 inches to 0.7 inches)
Mounting
hole
Mounting
hole
Median line
Median line
Rear view (PRO-940HD)
Mounting
hole
Median line
Median line
Mounting
hole
Rear view (PRO-1140HD)
PDP_PRO1140HD.book Page 11 Monday, June 5, 2006 5:22 PM