Pioneer PRO 940HD Flat Panel Television User Manual


 
32
En
TV Guide On Screen™ System Setup
07
Screen 8: Is a VCR Connected?
If you select “Yes”, you see Screen 9.
If you select “No”, you see Screen 14.
Screen 9: VCR Configuration Diagram
This screen shows the correct way to install the G-LINK cable
from the back of the device to the recording device. Make
sure the G-LINK cable is properly installed.
•Press ENTER to advance to Screen 10.
Screen 10: VCR Brand Name
Press / to select the brand of the recording device.
•Press ENTER to advance to Screen 11.
Screen 11: VCR Preparation
Follow the on-screen instructions then press ENTER to
display Screen 12.
Screen 12: VCR Code Testing
When testing is done, Screen 13 displays automatically.
Screen 13: Did your VCR stop playing?
If you select “Yes”, you see Screen 14.
If you select “No”, a different code is tested from Screen 12.
NOTE
Many VCRs require testing of more than one code to ensure
proper operation with the TV Guide On Screen™ system.
If you select “Test this code again”, the same code from
Screen 12 is sent again.
PDP_PRO1140HD.book Page 32 Monday, June 5, 2006 5:22 PM