Filter
Top Products
71
En
Using External Equipment
12
English
Computer compatibility chart
G-LINK™ connection
To record with a VCR through the TV Guide On Screen™
system, connect the VCR to the panel using the G-LINK cable.
NOTE
• In order to use a VCR with the TV Guide On Screen™ system,
confirm the factors listed below. See “TV Guide On Screen™
System Setup” on page 30.
• The G-LINK cable’s wand must be positioned so that its light
emitting section faces the VCR’s remote control sensor.
• The VCR is in Standby when selecting TV programs to record
using the TV Guide On Screen™ system.
• Avoid the cable loops when making the connection.
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core to the
connector end of the G-LINK cable as shown.
CAUTION
• Regarding the G-LINK cable, attach the supplied ferrite core.
If you do not do this, this Plasma Display will not conform to
mandatory FCC standards.
When connecting the VCR
Resolution Frequency
720 × 400 70 Hz
640 × 480 60 Hz
72 Hz
75 Hz
800 × 600 56 Hz
60 Hz
72 Hz
75 Hz
1024 × 768 60 Hz
70 Hz
75 Hz
1360 x 768 60 Hz
G-LINK cable
Ferrite core
As close as possible
Pull the cable slightly to
take up any slack
A
.
A
Plasma Display (rear view)
AV cable (sold
separately)
G-LINK cable (supplied)
Point to the remote
control sensor
VCR
G-LINK cable’s wand
Viewed from the bottom
of the Plasma Display
Ferrite core
PDP_PRO1140HD.book Page 71 Monday, June 5, 2006 5:22 PM