Filter
Top Products
67
En
Using External Equipment
12
English
Using HDMI Input
The INPUT 5 and INPUT 6 terminals are HDMI terminals for
digital video and audio signals. To use the HDMI terminal,
specify the types of video and audio signals being sent from the
connected equipment. For signal types refer to the device’s
operating manual.
Before bringing up the menu, press INPUT 5 (or INPUT 6) on
the remote control or press INPUT on the Plasma Display to
select INPUT 5 (or INPUT 6).
For audio, the panel supports the following:
• Linear PCM (STEREO 2ch)
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
NOTE
• PC signals are not supported.
• Images are sometimes slow to appear with some external
devices.
Connecting HDMI equipment
To specify the digital video signal type:
1 Press HOME MENU.
2 Select “Option”. ( / then ENTER)
3 Select “HDMI Input”. ( / then ENTER)
4 Select “Video”. ( / then ENTER)
5 Select the type of digital video signals. ( / then ENTER)
• If you select “Auto”, the panel automatically attempts to
identify the type of digital video signal.
6 Press HOME MENU again to exit the menu.
NOTE
• If you select a parameter other than “Auto”, verify that the
setting results in the appropriate colors.
• If no image appears, specify another digital video signal type.
• Refer to the external device’s operating instructions for
digital video signal types.
To specify the type of audio signals:
1 Press HOME MENU.
2 Select “Option”. ( / then ENTER)
3 Select “HDMI Input”. ( / then ENTER)
4 Select “Audio”. ( / then ENTER)
5 Select the type of audio signals. ( / then ENTER)
• If you select “Auto”, the panel automatically attempts to
identify the type of audio signal.
6 Press HOME MENU again to exit the menu.
NOTE
• If there is no sound, specify another audio signal type.
• Refer to the external device’s operating instructions for
audio signal types.
• Depending on the equipment to be connected, you may also
need to connect analog audio cables.
Input signal correlation table
19201080i@59.94/60 Hz
720480p@59.94/60 Hz
1280720p@59.94/60 Hz
720(1440)480i@59.94/60 Hz
19201080p@24 Hz
Plasma Display (rear view)
HDMI equipment
HDMI cable with
the HDMI mark
(sold separately)
Audio cable (sold
separately)
Use when inputting
analog audio signals.
Viewed from the bottom
of the Plasma Display
Item Description
Auto
(factory default)
Automatically identifies input digital video signals
Color-1 Digital Component Video signals (4:2:2) locked
Color-2 Digital Component Video signals (4:4:4) locked
Color-3 Digital RGB signals locked
Item Description
Auto
(factory default)
Automatically identifies input audio signals
Digital Accepts digital audio signals
Analog Accepts analog audio signals
PDP_PRO1140HD.book Page 67 Monday, June 5, 2006 5:22 PM