Filter
Top Products
Additional information
13
133
En
HOME MEDIA GALLERY
(SC-37 only)
Check Sirius Tuner The SiriusConnect™ tuner is not properly
connected.
Check that the 8 pin mini DIN cable and AC Adapter are
attached securely.
Acquiring Signal The SIRIUS signal is too weak at the current
location.
Check for antenna obstructions and reposition the
SIRIUS antenna to get better signal reception. Use the
Antenna Aiming option to optimize the antenna position.
Subscription Updating Unit is updating subscription. Wait until the channel subscription has been updated.
Updating Channels Unit is updating the channel information. Wait until the channel information has been updated.
Invalid Channel Selected channel is not available/does not
exist.
Select another channel.
Firmware Updating The SiriusConnect™ tuner’s firmware is
being updated.
Wait for updating to finish.
Symptoms Causes Remedies
Cannot access the network. The LAN cable is not firmly connected. Firmly connect the LAN cable (page 38).
The router is not switched on. Switch on the router.
Internet security software is currently installed in
the connected component.
There are cases where a component with Internet
security software installed cannot be accessed.
The audio component on the network which has
been switched off is switched on.
Switch on the audio component on the network
before switching on this receiver.
Playback does not start while
‘Connecting...’ continues to
be displayed.
The component is currently disconnected from
this receiver or the power supply.
Check whether the component is properly
connected to this receiver or the power supply.
The PC or Internet radio is not
properly operated.
The corresponding IP address is not properly set. Switch on the built-in DHCP server function of
your router, or set up the network manually
according to your network environment
(page 117).
The IP address is being automatically configured. The automatic configuration process takes time.
Please wait.
The audio files stored on
components on the network,
such as a PC, cannot be
played back.
Windows Media Player 11 or Windows Media
Player 12 is not currently installed on your PC.
Instal
l Windows Media Player 11 or Windows
Media Player 12 on your PC (page 64).
Audio files were recorded in formats other than
MP3, WAV (LPCM only), MPEG-4 AAC, FLAC, and
WMA.
Play back audio files recorded in MP3, WAV
(LPCM only), MPEG-4 AAC, FLAC, or WMA. Note
that some audio files recorded in these formats
may not be played back on this receiver.
Audio files recorded in MPEG-4 AAC or FLAC are
being played back on Windows Media Player 11 or
Windows Media Player 12.
Audio files recorded in MPEG-4 AAC or FLAC
cannot be played back on Windows Media Player
11 or Windows Media Player 12. Try using another
server. Refer to the operation manual supplied
with your server.
The component connected to the network is not
properly operated.
Check whether the component is affected by
special circumstances or is in the sleep mode.
Try rebooting the component if necessary.
The component connected to the network does
not permit file sharing.
Try changing the settings for the component
connected to the network.
The folder stored on the component connected to
the network has been deleted or damaged.
Check the folder stored on the component
connected to the network.
Status messages Cause Action
SC-37_35_UXJCB.book 133 ページ ２０１０年３月９日 火曜日 午前９時３２分