Pioneer SC-35 TV Receiver User Manual


 
Using other functions
09
82
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
Disconnect the iPod and USB memory device from
the receiver beforehand.
1 Switch the receiver into standby.
2 While holding down
ENTER
on the front panel,
press
STANDBY/ON
.
The display shows RESET NO .
3 Select ‘
RESET
’ using
PRESET /
, then press
ENTER
on the front panel.
The display shows RESET? OK.
4 Press
ENTER
to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting Default
Digital Video Conversion ON
SPEAKERS A
Speaker System Normal (SB/FH)
Speaker Setting Front SMALL
Center SMALL
FH/FW SMALL
Surr SMALL
SB SMALLx2
SW YES
Surround Position IN REAR
Crossover 80 Hz
X-Curve OFF
THX Audio Setting 4 ft<
DIMMER Brightest
Network Standby OFF
Inputs
See Input function default and possible settings on page 46.
HDMI
HDMI Audio Amp
HDMI output HDMI OUT ALL
Control ON
Control Mode ALL
DIsplay Power Off YES
DSP
Power On Level LAST
Volume Limit OFF
Mute Level FULL
Phase Control ON
Sound Retriever
iPod/USB, HOME
MEDIA GALLERY (SC-
37 only), INTERNET
RADIO (SC-35 only),
ADAPTER PORT
function
ON
Other functions
OFF
Sound Delay 0.0 frame
Dual Mono CH1
DRC AUTO
SACD Gain 0 dB
LFE Attenuate 0 dB
Auto delay OFF
Digital Safety OFF
Effect Level ExtendedStereo 90
Other modes 50
2 PL II Music
Options
Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs Listening Mode
(2 ch/multi ch)
AUTO
SURROUND
Listening Mode (HP) STEREO
See also Setting the Audio options on page 76 for other default
DSP settings.
MCACC
MCACC Position Memory M1: MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 10.00 ft
Standing Wave
(M1 to M6)
ATT of all channels/
filters
0.0 dB
SWch Wide Trim 0.0 dB
EQ Data (M1 to M6) All channels/bands 0.0 dB
EQ Wide Trim 0.0 dB
Setting Default
SC-37_35_UXJCB.book 82 ページ 2010年3月9日 火曜日 午前9時32分