Filter
Top Products
Connections & Setup
14 Chapter 2
Connections & Setup
Chapter 2 15
Connection 2: DIRECTV HD Receiver +
Monitor with component video input jacks
1. Connect the satellite signal to the HD Receiver.
Connect the satellite dish antenna feed (RG-6 coaxial cable) to the SATELLITE IN jack on the HD Receiver.
2. (Optional) Connect an off-air signal to the HD Receiver.
Use a coaxial cable (usually included with an off-air antenna) to connect an off-air antenna to the AIR IN jack on the
back of your HD Receiver.
3. Connect a cable signal (if available) to the HD Receiver.
Connect the coaxial cable from your cable outlet to the CABLE IN jack on the back of your HD Receiver.
4. Connect a phone line to the HD Receiver.
Connect one end of the supplied phone cord to an RJ11-type modular telephone wall jack (the most common type of
phone jack). Connect the other end to the PHONE jack on the back of the HD Receiver.
5. Connect the component video output jacks from the HD Receiver to your monitor's component video input jacks.
Connect the ends of the component video cables to the COMPONENT VIDEO jacks on the HD Receiver. Connect the
other ends of the component video cables to the corresponding input jacks on the back of the TV or monitor.
Note: Make sure you connect jacks corresponding to their labels. For example, the PR output on the HD Receiver
should be connected to the PR input on the monitor, the PB output to the PB input, and the Y output to Y input. Make
sure you use video-grade video cables.
1
2
3
4
5
6
7