Filter
Top Products
Operation
CX-47HD/CX-OPAL47/CX-65HD Installation/Operation Manual 37
PRE
L
IMINAR
Y
Baud Rate: Select Baud Rate from the Setup menu to set the data transfer rate of the
Crystal Series LCD’s RS-232 port. (This setting must match the data rate of the device
connected to the RS-232 input.)
SCART: Set SCART to On if you are using the Component 1 and Video 1 inputs to
connect a SCART source (see Figure 3-5). When you do, the Source menu appears as
shown here (Component 1 and Video 1 are not available).
Source Enable: Select Source Enable from the Setup menu to disable inputs that you
are not using. By default, all inputs are enabled.
Disabling unused inputs causes the main input select function (using the SOURCE button
on the LCD keypad) to skip over them, saving time. The PIP input select function (using
the PIP
SRC button on the remote control unit) is similarly affected.
•HDMI 1/HDMI 2/HDMI 3/HDMI 4: Enables or disables an HDMI source.
• Component 1/Component 2: Enables or disables the Component 1 or Component 2
source.
• RGB: Enables or disables the RGB source.
•Video 1/Video 2: Enables or disables the a video source.
LED Option: Select LED Option from the Setup menu to change the behavior of the
front-panel status indicator LED (see Figure 2-1) during standby mode.
When set to ON, the LED lights orange to indicate that the Crystal Series LCD is in
standby mode. When set to OFF, the LED is always off, regardless of the operational state
of the Crystal Series LCD.
System Info: Select System Info from the Setup menu to see information that uniquely
identifies your display: its model number, serial number and installed firmware version.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
> HDMI 1
HDMI 2
HDMI 3
HDMI 4
SCART
Component 2
RGB
Video 2
If either Component 1 or Video is enabled, SCART must be disabled.
Note