Filter
Top Products
Serial Communications
CX-47HD/CX-OPAL47/CX-65HD Installation/Operation Manual 49
PRE
L
IMINAR
Y
[ SDE 000#
Set PIP aspect ratio
0 = 4:3
1 = 16:9
Example: [SDE0001 selects 16:9 aspect ratio PIP window
[ SDF 000#
Set PIP window position
0 = Top/Left
1 = Top/Right
2 = Bottom/Left
3 = Bottom/Right
Example: [SDF0001 positions PIP window in upper-right corner of display area
The following serial commands are meant to emulate buttons on the remote control. Each button
has its own serial command, so effectively it is as if you were using the IR remote only you’ll be
doing so via serial commands. These commands provide active OSD responses just like the IR
remote.
Each command begins with [key followed by the four-digit number of the button. No carriage
return is necessary. The response you receive from the unit if the command is valid will be a
right-bracket (
]) followed by the four-digit numeric code you sent. (For example, the ‘ON’ com-
mand is [key0015; the response will be ]0015). All commands are in ASCII.
[ key 0002
OFF
0015
ON
[ key 0004
Number 1
0005
Number 2
0006
Number 3
0008
Number 4
0009
Number 5
0010
Number 6
0012
Number 7
0013
Number 8
0014
Number 9
0035
Number 100
0017
Number 0
[ key 0102
HDMI 1
0101
HDMI 2
0093
HDMI 3
0094
HDMI 4
0028
Component 1/SCART
Table 6-1. Serial Commands (continued)
Command Description