Filter
Top Products
Controls and Functions
Runco CinemaWall SP-42/-50/-60 Owner’s Operating Manual 11
PRE
L
IMINAR
Y
3. MENU
Press this button to show or hide the OSD controls.
4. Directional Buttons ( / / / )
Use these buttons to navigate the OSD menus and adjust various settings.
5. SET BUTTON
Press this button to adjust or enter various settings on the unit.
6. SUB INPUT
When using the Picture-in-Picture (PIP) feature, press this button repeatedly to select
a sub-input source.
7. SPLIT
Press this button to change the PIP mode (picture-in-picture, side-by-side or off).
8. MUTE
Press this button to mute the speakers connected to the CinemaWall speaker
outputs. Press it again to restore the sound.
9. P-OFF (pin hole)
Using a straightened paper clip or similar object, press this button to program a
discrete IR code for powering off the CinemaWall into a control/automation system.
10. RGB SETUP
When using INPUT 1 to display images from a computer, press this button to
automatically set the Position, Clock and Phase settings to their optimum values.
11. STANDBY/ON ( )
Press to put the display into operation or standby mode.
12. INFO
Displays currently-selected input, aspect ratio and signal timing information.
13. INSTALLER ADJUST (pin hole)
Used to access the INSTALLER ADJUST menus.
14. MAGNIFY
Press this button to select and enlarge one part of the screen image.
15. SWAP
When using the Picture-in-Picture (PIP) feature, press this button to replace the main
screen with the sub-screen or vice versa.
16. PIP SHIFT
Press this button to change the position of the smaller PIP sub-window (lower right,
upper right, lower left or upper left).
17. VOLUME + / -
Use these buttons to increase or decrease the volume of sound from the speakers.
18. CLEAR (pin hole)
Using a straightened paper clip or similar object, press this button to clear a screen
maintenance program (refer to
Program Timer (SP-42) / Screen Maint.
(SP-50/SP-60) on page 43).
19. P-ON (pin hole)
Using a straightened paper clip or similar object, press this button to program a
discrete IR code for powering on the CinemaWall into a control/automation system.