Filter
Top Products
Runco CinemaWall SP-42/-50/-60 Owner’s Operating Manual 13
PRE
L
IMINAR
Y
3.1
Remote Control
To install batteries in the remote control:
1. Remove the battery cover from the
back of the remote control.
2. Insert the batteries included with the
remote control. Ensure that the
polarities correctly match the
and
markings inside the battery
compartment.
3. Replace the battery cover.
Notes on Batteries• When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation
The remote control can be used to control the CinemaWall within the ranges shown in
Figure 3-1.
Figure 3-1. Available Range of the Remote Control
3. Installation
While pressing down lightly, slide
in the direction of the arrow.
Two AA (R6)
batteries
30°
30°
7 m
(23 feet)
Remote Sensor