Runco SP-60 Home Theater Screen User Manual


 
Installation
16 Runco CinemaWall SP-42/-50/-60 Owner’s Operating Manual
PRE
L
IMINAR
Y
3.3
Installation
Considerations
Proper installation of your CinemaWall will ensure the highest possible picture quality.
Whether you are installing the CinemaWall temporarily or permanently, you should take
the following into account to ensure that it performs optimally.
High-Altitude Operation Due to the design of all plasma glass panels made by every manufacturer, and the
interaction between ambient air pressure and the plasma gases contained inside of the
panel, reliable operation of your plasma display cannot be assured during operation at
certain high-altitude locations.
Runco has found this plasma monitor to operate reliably at altitudes of up to 6000 MSL
(mean sea level). At elevations higher than this, each panel may react differently,
depending upon the altitude, air pressure, humidity and other meteorological factors.
For this reason, Runco International makes no warranties or claims as to the reliable
operation of the CinemaWall at altitudes greater than 6000 feet above sea level. If you are
planning to use this product at a location above 6000 feet, please contact Runco
technical support for further information.
Mounting the CinemaWall
on a Wall or
Table Stand
To install the CinemaWall, you will need either an optional table stand or wall-mounting kit.
The CinemaWall cannot be installed on its own.
If you do decide to wall-mount the CinemaWall, ensure that the wall-mount bracket is
installed according to the instructions included with it. The wall must be capable of
supporting a redundant weight factor three (3) times the weight of the display, or be
reinforced.
Runco recommends that this be done by a custom installation specialist.
You can attach your optional mounts or stand to the CinemaWall in either of two ways:
While it is upright.
Use only a Runco-approved wall-mount kit or table stand that is
specifically designed for your display.
Note