Runco SP-60 Home Theater Screen User Manual


 
Operation
42 Runco CinemaWall SP-42/-50/-60 Owner’s Operating Manual
PRE
L
IMINAR
Y
Time/Date: Select Time/Date from the Option menu to set the CinemaWall’s internal
clock (time of day and day of the week) and turn the screen maintenance feature on or off.
Present Time: To set the internal clock, highlight Present Time and press SET.
Then, use the right- or left-arrow buttons ( , ) to set the time. Press SET again
when you are finished.
Program Timer: Set Program Timer to ON to enable the CinemaWall’s screen
maintenance feature, which lets you replace the normal source signal with a white field,
an inverse image or an “orbiting” image. This occurs according to the schedule you
establish using the
Program Timer (SP-42) / Screen Maint. (SP-50/SP-60) menu in
Installer Adjust mode (refer to Program Timer (SP-42) / Screen Maint.
(SP-50/SP-60) on page 43).
Select Return to exit the Time/Date menu.
PDP Mgmt: Select PDP Mgmt. from the Option menu to configure the image burn-in
prevention settings on the CinemaWall.
Orbiter: Select Orbiter from the PDP Mgmt. menu to set the picture shift.
OFF: Orbiter mode does not function.
TYPE 1: The image size is reduced so the entire image remains in the display area
while orbiting.
TYPE 2: The image is enlarged so there are no black bands in the display area while
orbiting.
TYPE 3: The image size is unchanged.
Soften: Select Soften from the PDP Mgmt. menu to reduce edges (color transitions)
and soften the image.
OFF: Turns the SOFTEN function off.
1, 2, 3, 4: Activates the SOFTEN setting. Higher numbers create a “softer” image.
Auto Setup Mode: The CinemaWall can automatically adjust the position, frequency and
phase of incoming computer signals for optimum picture quality whenever the display is
turned on, or when a different input or input signal type is selected. To enable this feature,
select
Auto Setup Mode from the Option menu and set it to ON.
1. When TYPE 1 or TYPE 2 is selected, the image movement is
continuous; TYPE 3 causes the image to move one pixel at a
time.
2. The Orbiter does not function while the MAGNIFY feature is in
use.
Under some conditions – such as when the input signal consists of
mostly dark colors – Auto Setup may not produce the desired
results. If this occurs, set Auto Setup Mode to OFF and manually
adjust the image position, frequency and phase; refer to
Screen on
page 38.
Note
Note