Filter
Top Products
GB
11
Connecting DVD-VCR to the TV using the Coaxial Cable
Connecting DVD-VCR to the TV using the SCART Cable
To receive television programmes a signal must be received from
one of the following sources:
◆ An outdoor aerial
◆ An indoor aerial
◆ A cable television network
◆ A satellite receiver
☛ Make sure that both the television and the DVD-VCR
are switched off before connecting the cables.
1 Remove the aerial or network input cable from the television.
2 Connect this cable to the 75Ω coaxial socket marked on
the rear of your DVD-VCR.
3 Plug the coaxial cable supplied into the socket on your
DVD-VCR.
4 Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
5 To obtain better pictures and sound quality on your television,
you can also connect your DVD-VCR to the television via the
SCART cable (see section below) if your television is equipped
with this type of connection.
TV
You can connect your DVD-VCR to the television using the SCART cable if the appropriate input is
available on the television. You thus:
◆ Obtain better quality sound and pictures
◆ Simplify the setting up procedure of your DVD-VCR
☛ ◆ Regardless of the type of connection chosen, you must always connect the coaxial cable
supplied. Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.
◆ Make sure that both the television and the DVD-VCR are switched off
before connecting the cables.
1 Connect the coaxial cable as indicated in the above section.
2 Connect one end of the SCART cable to the AV1 (EURO AV) socket on the rear of the DVD-VCR.
3 Plug the other end into the appropriate connector on the television.
RADIO ANT.
AM
FM
75
COAXIAL
AUX
IN OUT
AUDIO
VIDEO
DVD & VCR
R
L
RADIO ANT.
AM
FM
75
COAXIAL
AUX
IN OUT
AUDIO
VIDEO
DVD & VCR
R
L
3
2
TV
4
RADIO ANT.
AM
FM
75
COAXIAL
AUX
IN OUT
AUDIO
VIDEO
DVD & VCR
R
L
Aerial
SCART Cable
RF coaxial cable
2
3
TV