Filter
Top Products
GB
69
About Speaker Setup
To Set the Speaker Balance
1 Press the SPEAKER button.
Each time you press the button, the selection will change as
follows: FL
"
C
"
FR
"
SR
"
SL
"
SU
"
VOL.
2 Press AMP VOL + and AMP VOL - buttons to adjust the
speaker volume.
The volume can be adjusted to a level between –10 and +10.
To Test the Speakers
1 In Stop mode, press the TEST button.
◆ The test tone will be output to the speakers in the following
order: FL (Front Speaker/L)
"
C (Center Speaker)
"
FR
(Front Speaker/R)
"
SR (Surround Speaker/R)
"
SL
(Surround Speaker/L)
"
SU (Subwoofer).
◆ A hissing sound from a speaker indicates that the speaker is
installed correctly.
2 To end the speaker test, press the TEST button again.
➢ •
While the test tone is being produced, you can use the
VOL buttons to set the speaker balance for the selected
channel.
• While the subwoofer is being tested, a low bass sound of
100Hz or 125Hz will be heard.
To Set the Bass/Treble
1 Press the BASS or TREBLE button.
Each time you press the BASS or TREBLE button, the
corresponding setting will turn on or off.
2 Use AMP VOL + and AMP VOL - buttons to adjust the bass or
treble of the speakers.
The bass or treble can be adjusted to a level between –10 and
+10.
1
1,2
1
1
2
2
2
2
FL
FRONT SPEAKER
LEFT
FRONT SPEAKER
RIGHT
CENTER SPEAKER
SURROUND SPEAKER
RIGHT
SURROUND SPEAKER
LEFT
SUB WOOFER
SPEAKER
C
SUB
WOOFER
FR
SRSL