Filter
Top Products
GB
32
Using the ShowView
Before presetting your DVD-VCR:
◆ Switch on both the television and your DVD-VCR
◆ Check that the date and time are correct
◆ Insert the cassette on which the programme is to be
recorded (safety tab intact)
Up to six programmes can be preset.
1 To enter a ShowView, press the TIMER button.
Press the
#
or
❷!
and OK or
❿!
buttons to select ShowView
Result: A message is displayed to allow you to enter the
ShowView code.
☛ If all six programmes have been set, the message Timer
is full is displayed. Refer to page 35 if you wish to
cancel a preset recording.
2 Press the numeric buttons to enter the code opposite the
programme that you wish to record in your television magazine.
➢ If you wish to correct the ShowView code that you are
entering:
◆ Press the
➛
button until the digit to be corrected is
cleared
◆ Enter the correct digit
3 Press the OK button.
Result
:
The information concerning the programme is
displayed.
☛ When using the ShowView function for the first time with
stored stations, the programme number flashes. This one
time, you must enter the station number manually by
pressing the
#
or
❷
buttons. Refer to the following page
if:
◆ The programme number or times flash
◆ You wish to modify the programme
4 If the programme and times are correct, press the RETURN
button.
5 Press the STANDBY/ON button to activate the timer.
6 Refer to page 35 if you wish to:
◆ Check that your DVD-VCR has been programmed correctly
◆ Cancel a preset recording
☛ The numbers next to each TV programme listing are
ShowView code numbers, which allow you to
programme your videorecorder instantly with the
remote control. Tap in the ShowView code for the
programme you wish to record.
™ ShowView is a trademark of Gemstar Development Corporation. The ShowView system
is manufactured under licence from Gemstar Development Corporation.
VCR
Standard
ShowView
Timer Method
5
1