Filter
Top Products
67
GB
Programming the Timer with G-CODE
®
System
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
ANGLE
PROG
DV- NC70
DV- NC70X
G-CODE
DV- NC70W
7 Press VCR MENU to return to the normal screen.
8 To set the product for automatic timer recording, press TIMER
ON/OFF and ensure the “
” lights on the VCR Front Panel
display.
—
• Please be sure to check that the start and end times of two different
programmes do not overlap, as the remote control has been designed
to accept the basic individual G-CODE number only. If the recording
periods of two programmes overlap, the beginning of the second
programme will not be recorded.
• To cancel the programmed G-CODE setting, select the TIMER setting
mode on the menu screen. Then select the programme number you
wish to cancel with ' / " and press CLEAR. (See “Cancelling Timer
Programmes” on page 72.)
Setting the Programme Number In Step 4
When using the G-CODE system for the first time the Programme
number (PR) on the screen shows two dashes and is highlighted
white. Set it to be the same as the PR number to which your broad-
casting channel is set into.
For instance if you can view CH 47 on programme (PR) 47, set the
On screen PR number to 47.
• You need to set this only once.
• If the channels are retuned you need to set the PR numbers again.
DATE PR START STOP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
1/2
15/12 -- 12:00 12:30 SP
PMPM
:SELECT :CHANGE
SET:ENTER MENU:EXIT
PR :PRESET CH
SEPVP D
VCR
VCR
L R
PR: Preset Channel