Filter
Top Products
20 (GB) Chapter 1 Overview
Location and Function of Parts
Chapter 1 Overview
.........................................................................................................................................................................................................
1) LANC (Local Application Control bus system):
Bidirectional interface to control a consumer VCR
Notes
• If video signals have been input to the DV jack and
you output these video signals to the S VIDEO or
VIDEO connectors, the sync and burst of the
corresponding EE pictures are not synchronized.
• i.LINK and the i.LINK logo “
” are trademarks and
indicate that this product is in agreement with IEEE
1394-1995 specifications and their revisions.
• This jack can accept only DV signals.
• If the unit is connected to a device equipped with a 6-
pin DV jack, when you intend to disconnect or
reconnect the DV cable, turn off the device and pull
out the plug of its power cord from the AC outlet
beforehand. If you connect or disconnect the DV
cable while the device is connected to the AC outlet,
high-voltage current (8 to 40 V) is output from the
DV jack of the device to this unit, which may cause a
malfunction.
•When connecting a device that has a 6-pin DV jack to
this unit, first, connect the plug of the cable to the 6-
pin DV jack.
6 AC IN connector
Connects to an AC outlet using the supplied power
cord.
Even if the unit is in the standby mode, it consumes
power. To turn the unit off completely, pull the plug
out from the AC outlet.
7 CONTROL S IN jack (stereo minijack)
Connects to the Remote Control Unit (DSRM-20, not
supplied) for controlling this unit.
Note
When using the Remote Control Unit (DSRM-20, not
supplied), set COMMANDER on the OTHERS menu
to CONTROL S.
8 LANC jack
Use when controlling the tape transport operation of
the unit using a device that has a LANC
1)
jack.
Notes
• The LANC jack on the unit has only LANC-S
functions. The unit has no LANC-M functions. A
device that is set to LANC-S mode cannot be
connected to this unit. Either this, the unit or the other
device may not operate properly.
• If the device that you connect to this unit has a
SHUTTLE A/B switching function and a LANC-M
function, set the device to the SHUTTLE B mode.
• The LANC connection transmits signals such as
control signals, time code, time counter data, and
status data.
• Jacks labeled CONTROL L have the same function
as LANC jacks.
•When using this unit as a player, set the LANC mode
on the recorder to M. A device that does not have an
M / S switching function cannot be used to control
this unit.