Filter
Top Products
Location and Function of Parts
Chapter 1 Overview
26 Chapter 1 Overview
Optional board/timecode/remote control/power input and output section
1 REMOTE connector
2 TC IN connector
3 DC IN connector
4 TC OUT connector
AUDIO INPUT VIDEO
S VIDEO
REMOTE
REF. INPUT
IN
OUT
DC IN
OUTPUT
AUDIO OUTPUT
MONITOR
TC IN
TC OUT
CH-1 CH-2
1
2(SUPER)
AUDIO
OUT
R-Y B-Y
Y
IN
1/3 2/4
0
-60 +4dbu
0
-60 +4dbu
75Ω 75Ω
ONOFF
OUTIN
ONOFF
Cable clamp
5 Optional interface board fitting
port
a)
a) This illustration shows the DSR-70/70P fitted with the optional DSBK-170.
1 REMOTE (9-pin remote control) connector
(D-sub 9-pin)
When editing with two DSR-70/70P units, connect this
connector on each unit using a 9-pin remote control
cable (not supplied). When editing with this unit and
external equipment, connect the external equipment.
2 TC IN (timecode input) connector (BNC type)
To record timecode from an external device, input the
timecode from the external device’s timecode output
connector.
3 DC IN (external power input) connector (XLR
4-pin, male)
To power this unit with AC power, connect to the DC
output connector of the AC-550/550CE AC adaptor.
You can also connect a BP-90/90A Battery Pack using
the DC-210 Battery Adaptor.
Power supplied through this connector is used on a
priority basis even when you have connected a battery
pack or AC-DN2/DN2A AC Adaptor to the battery
connector on the top panel.
For more information, see “Power Preparations” on page
29.
4 TC OUT (timecode output) connector
(BNC type)
Outputs the following types of timecode, depending on
the VCR operating status.
During playback: The playback timecode
During recording: The timecode generated by the
internal timecode generator, or the timecode input
through the TC IN connector.
For details of the timecode output during recording, see
setup menu item 611 (page 109).
5 Optional interface board fitting port
Install any one of the following optional interface
boards here:
• DSBK-140 i.LINK/DV Input/Output Board
• DSBK-150 SDTI (QSDI) Input/Output Board
• DSBK-160 SDI Input/Output Board
• DSBK-170 Analog Component Input/Output Board
The connectors provided by the optional boards are as
follows.