Filter
Top Products
20
Controlling the volume of your AV
amplifier (receiver) with the remote
1 Slide the TV/DVD switch to DVD.
2 Hold down [/1, and enter the
manufacturer code (see the table below)
for your AV amplifier (receiver) using the
number buttons.
3 Release [/1.
The 2 (volume) +/– buttons control the AV
amplifier’s volume.
If you want to control the TV’s volume, slide
the TV/DVD switch to TV.
z Hint
If you want to control the TV’s volume even when the
TV/DVD switch is set to DVD, repeat the steps above
and enter the code number 90 (default).
Code numbers of controllable AV amplifiers
(receivers)
If more than one code number is listed, try
entering them one at a time until you find the one
that works with your AV amplifier (receiver).
If you have a Sony DVD player or
more than one Sony DVD recorder
If the supplied remote interferes with your other
Sony DVD recorder or player, set the command
mode number for this recorder and the supplied
remote to one that differs from the other Sony
DVD recorder or player.
The default command mode setting for this
recorder and the supplied remote is “MODE3.”
1 Turn off the recorder.
2 Press down x (stop) on the recorder until
“MODE” appears in the front panel
display.
3 While keeping x (stop) pressed,
repeatedly press ./> on the
recorder to select the command mode
(MODE1, 2, or 3).
4 Slide the COMMAND MODE switch on the
remote so it matches the mode you
selected above.
Manufacturer Code number
Sony 78, 79, 80, 91
Denon 84, 85, 86
Kenwood 92, 93
Onkyo 81, 82, 83
Pioneer 99
Sansui 87
Technics 97, 98
Yamaha 94, 95, 96
TV/DVD
switch
"/1
2 +/–
Number
buttons
1 2 3
4 5 6
7 8 9
0
x
./>
COMMAND
MODE switch
Front panel display