Sony RDR-GXD360 DVD Recorder User Manual


 
17
Hookups and Settings
2 With the TV [/1 button pressed down,
enter the TV’s manufacturer code
using the number buttons.
For instance, to enter “09,” press “0” then
“9.” After you enter the last number,
release the TV [/1 button.
Code numbers of controllable TVs
If more than one code number is listed,
try entering them one at a time until you
find the one that works with your TV.
The remote performs the following:
To operate the TV/DVD button
(for SCART connections only)
The TV/DVD button switches between the
recorder and the last input source selected on
the TV. Point your remote at the recorder
when using this button.
When you connect the recorder to the TV via
the SCART jacks, the input source for the TV
is set to the recorder automatically when you
start playback. To watch another source,
press the TV/DVD button to switch the TV’s
input source.
If the supplied remote interferes with your
other Sony DVD recorder or player, set the
command mode number for this recorder and
the supplied remote to one that differs from
the other Sony DVD recorder or player after
you have completed “Step 6: Easy Setup.”
The default command mode setting for this
recorder and the supplied remote is DVD3.
1 Check that “Easy Setup” (page 19)
has been finished. If “Easy Setup” has
not been finished, first perform “Easy
Setup.”
2 Press SYSTEM MENU.
The System Menu appears.
Manufacturer Code number
Sony 01 (default)
Grundig 11
Hitachi 24
ITT/Nokia 15, 16
JVC 33
Loewe 45
Nokia 69, 73
Panasonic 17, 49
Philips 06, 07, 08, 72
Saba 12, 13, 74
Samsung 22, 23, 71
Sanyo 25
Sharp 29
Telefunken 36
Thomson 43, 75
Toshiba 38
Buttons Operations
TV [/1 Turns your TV on or
off
TV 2 (volume)
+/–
Adjusts the volume
of your TV
TV PROG +/– Selects the
programme position
on your TV
TV t Switches your TV’s
input source
If you have a Sony DVD player
or more than one Sony DVD
recorder
SYSTEM
MENU
M/m,
ENTER
Number
buttons
,continued