Filter
Top Products
14
GB
Operating Your Components with
the Remote Commander
(continued)
To control the volume
Press the 2 +/– buttons to control the
volume, and the % button to mute.
When you select a visual component, the
TV’s volume will be controlled, and
when you select an audio component, the
amplifier’s volume will be controlled.
You can change this setting also (page
22).
Notes
•If you have programmed any signal for the
2 or % button for any component using the
learning function (page 16), that signal will
be transmitted instead of controlling the
volume of the TV or amplifier once you select
that component.
•If you have programmed any signal for the
2 or % button of TV or AMP using the
learning function, that signal will be
transmitted only after you select TV or AMP.
When you select another components, the
preset volume control signals for TV or AMP
will be transmitted at that time.
•If you have assigned another component to
the TV or AMP button (page 35), the volume
of the TV or amplifier cannot be controlled
even when you select other components.
2 Press the desired key in the
touch-key display.
When the remote control signal is
sent, is displayed on the display.
You may also use the 2 +/– buttons,
the % button and the PROGRAM +/–
buttons if necessary.
See “Table of Preset Functions” (page
56) for the functions of keys and
buttons for each component.
3 When you are done using the
Commander, press
COMMANDER OFF to power off
the Commander.
Note
The remote control signals may be different for
some components or functions. In this case,
programme the remote control signals with the
learning function (page 16). Note, however,
that components and functions that do not
support the remote control of infrared signals
will not work with this Commander.