Filter
Top Products
40
GB
If the power-on/off operation
does not work correctly
The air-conditioner may not be turned on
or off properly with the button of this
Commander, for which you have
programmed its power-on/off signal.
If the Commander can operate only
“ON” with one button and “OFF” with
another, while your air-conditioner’s
remote control can operate “ON/OFF”
with a single button, programme the
signal on two buttons of the Commander
as follows.
1 Clear the learned power-on/off signal.
(In the example on page 39, clear the
learned signal from the SYSTEM
CONTROL 2 button.)
2 Programme the signal (transmitted
from the power-on/off button of the
air-conditioner’s remote control) for
the SYSTEM CONTROL 2 button
again.
3 Programme the signal from the same
button of the remote control for
another button (for example, the
SYSTEM CONTROL 3 button).
The two buttons of the Commander have
been programmed with the power-on
signal and the power-off signal of the air-
conditioner, respectively so that you can
operate the air-conditioner with the
Commander.
Programming a Frequently Used
Key Operation for SYSTEM
CONTROL Buttons (continued)
Note
You can programme a remote control signal for
a SYSTEM CONTROL button by “learning” for
which the System Control functions have been
programmed. In this case, the System Control
functions are overwritten and cannot be used.
If you clear the “learned” signal from the
button, the System Control function, are
restored, and you can use them again.
To clear the learned remote
control signal
1 While pressing COMMANDER OFF,
press PROGRAM + and 2 +.
2 While pressing the RESET key, press
the SYSTEM CONTROL button (1, 2,
or 3).
3 Press COMMANDER OFF.
The display for that button flashes.
If you want to programme a new signal
for that button, follow Steps 3 to 5.
Notes on learning the signals
of an air-conditioner
About seasonal adjustments
If you change the settings of the air-
conditioner for the season, you have to
programme the remote control signals of
the new settings on the Commander.