Filter
Top Products
34
GB
Turning Off the Power
of All Components with
the Touch of a Single
Button
— System Power-Off Function (for
Sony Components only)
When the System Power-Off function is
active, you can turn off all Sony
components just by pressing the
COMMANDER OFF button for three
seconds.
Notes
•Some Sony components may not be turned
off with this function.
•The power-off signals are transmitted at
intervals that are set for the System Control
function set for the SYSTEM CONTROL 1
button (page 30). If you change the interval
for the SYSTEM CONTROL 1 button, the
interval of the System Power-Off function is
also changed.
To set the System Power-Off
function
To clear the learned function of
the Component Select button
1 While pressing COMMANDER OFF,
press PROGRAM + and 2 +.
2 While pressing the RESET key, press
the Component Select button which
you want to clear.
Notes
•You can programme a signal by “learning”
for a Component Select button for which a
System Control function (page 28) or the
Power-On function (page 31) has been
programmed. In this case, the System Control
function or the Power-On function is
overwritten and cannot be used. If you clear
the “learned” signal from the button, the
System Control function or the Power-On
function is resumed, and you can use it again.
•You cannot programme a System Control
function (page 28) for a Component Select
button for which a signal has been
programmed by “learning.”
•You can programme the Power-On function
for a Component Select button for which a
signal has been programmed by “learning,”
but then the Power-On function cannot be
used. If you clear a “learned” signal from the
button, you can use the Power-On function.
Adding an Extra Function to the
Component Select Buttons
(continued)