Filter
Top Products
33
GB
Example: To programme the
input select signal of your
amplifier to the CD button
1 Place the RM-AV2100T head to
head with your component’s
remote control.
2 While pressing COMMANDER
OFF, press PROGRAMME + and
2 +.
“LEARN” appears and all the
component names flash.
Note
The name of a Component Select button for
which a signal has already been learned
stays lit. If you want to programme a new
signal for that button by learning, clear the
learned signal first (page 34).
about 5 – 10 cm
(2 – 4 inches) away
RM-AV2100T
Remote control of
your component
3 Press the desired Component
Select button.
The selected component name stays
lit and “LEARN” flashes.
4 Press and hold down the button
on the component’s remote
control (amplifier in this example)
until you hear a beep.
(If you release the button before
you hear a beep, the signal may
not be learned correctly.)
“LEARN” stops flashing and stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and
4 again.
5 Press COMMANDER OFF.
Continued