Filter
Top Products
89
Chapter 10: Appendix
Searching for a device code
If you do not know the device code for a particular
device, you can view each available code for that device
mode and sample the functions to find the code that
operates the target device.
1 Press a mode select button on the remote.
2 While holding down Q, press 8, 5, 0, 0. The mode
select button blinks twice. The remote control enters
program mode.
3 Point the remote at the target device Press , 1,
, , or . The mode select button lights up.
Then press B or b to change a code.
4 If the device responds to the remote control:
Press Q to store the device code. The mode select
button blinks twice. The remote exits program
mode.
5 If the device does not respond to the remote control:
Repeat this step until the device responds to the
remote.
When no code is found, exit the program mode by
the following operation:
•Press Q. (current state is stored)
•Press no key for 10 seconds. (current state is not
stored)
Note: When a search cycle is completed, the remote
displays each available code again. If no key is pressed
within 10 seconds, the remote exits program mode and
returns to the previous code.
Locking the volume keys
The remote’s volume keys ( , , and MUTE) are
locked to a device mode.
See “Operating other devices” (- p. 88).
To lock the remote’s volume keys to a specific mode:
Example: CABLE/SAT mode
1 Press CABLE/SAT.
2 While holding down Q, press 8, 0, 0, 0.
3 Press . The CABLE/SAT mode select button
blinks 2 times (locked).
The remote’s volume keys now operate the volume
of the device associated with the CABLE/SAT
mode, even when CABLE/SAT is not the current
device mode.
To unlock the remote’s volume keys:
1 While holding down Q, press 8, 0, 0, 0.
2 Press . The CABLE/SAT mode select button
blinks 4 times. The CABLE/SAT mode is unlocked.
Clearing the remote’s programming
You can clear all programmed remote control features
not related to “Device code setup” and reset the volume
lock to the TV device mode.
While holding down Q, press 8, 9, 0, 0. The mode
select button blinks 4 times.
Resetting to the factory default
You can clear changed manufacturing features.
While holding down Q, press 8, 9, 0, 1. The mode
select button blinks 4 times.
State Meaning
Locked (default)
The remote operates the TV’s volume
except the AUX mode, even when the
TV is not the current device mode.
Unlocked
The remote operates the volume of the
device associated with the current
device mode.
Each device mode has its own volume
(if the device ID has volume data).
Locked to a
specific device
mode
The remote operates the volume of the
device associated with the locked
mode, even when the locked mode is
not the current device mode.
Note: The AUX mode is not locked to
other device modes.
POWER
VOL
CH
VOL
VOL
VOL
VOL