Filter
Top Products
6
which may damage the surface. Never spray volatile
compounds such as insecticide onthe cabinet.
Such products may damage or discolor the cabinet.
37) Never hit, press, or place anything onthe back cover.
These actions will damage internal parts.
38) WARNING:
RISKOFELECTRICSHOCK!
Never spillliquidsor push objects of any kind into
the TV cabinet slots.
39) During a lightning storm, do not touch the connecting
cables or product.
40) For added protection of your TV from lightning and
power surges, always unplug the power cord and
disconnect the antenna from theTV ifyou leave the TV
unattended or unused for long periods of time.
41)Always unplug the "IV to completely disconnect from
mains power. When the TV is turned off usingthe on/
offswitch, it isnot completely disconnected from power
and aminute amount of current is stillconsumed.
42) During normal use, the TV may make occasional
snapping or popping sounds. This is normal, especially
when the unit is being turned on or off. Ifthese sounds
become frequent or continuous, unplug the power cord
and contact a Toshiba Authorized Service Provider.
43) _ WARNING: RISK OF SERIOUS
• PERSONAL INJURY OR EQUIPMENT
...... DAMAGE!
Never strikethe screen with a sharp or heaW object.
44)
. The LCD screen ofthis product can be damaged by
ultraviolet radiation from the sun. When selecting a
location for the television, avoid locations where the
screen may beexposed to direct sunlight, such as in
front of a window.
. Never touch, press, or place anything on the LCD
screen. These actions will damage the LCD screen.
Ifyou need to clean the LCD screen, follow the
instructions in item 35) on page 5.
Service
45)
WARNING: ,_i ...........
,, RISKOF ELECTRICSHOCK!
Never attempt toservice the TVyourself. Opening
and removing the covers may expose you to
dangerous voltage or other hazards. Failure to
follow this WARNING may result in death or
serious injury. Refer all servicing not specified in
this manual to aToshiba Authorized Service
Provider.
46) Ifyou have the TV serviced:
Ask the service technician to use only replacement
parts specified by the manufacturer.
* Upon completion ofservice, ask the service
technician to perform routine safety checks to
determine that the TV is in safe operating condition.
ChoosingalocationforyourLEDTV
To Display your LEDTV on the incJuded PedestaJ Stand:
Observe the following safety precautions:
1) Read and follow the pedestal assembly instructions
included with the pedestal.
CAUTION: Before beginning pedestal assembly,
carefully lay the front of the LCD Panel face down
on a flat, cushioned surface such as a quilt or
blanket. Leave the bottom of the unit protruding
over the edge of the surface and assemble the
pedestal as described in this instruction document.
Note: Extreme care should always be used when
attaching the pedestal stand to avoid damage to
the LCD panel.
2) Place the TV ona sturdy, level surface that can
support the weight ofthe TV.
3) Be sure to secure the TV to a wall, pillar, surface, or
other immovable structure see item 26) on page 5 for
additional details.
To Display your LEDTV using aWalJ Bracket:
If you decide to wall mount your LED TV, always use a
wall bracket Listed by an independent laboratory (such
as UL, CSA, ETL) that is appropriate for the size
and weight of the TV:
1) CAUTION: Two people arerequired for installation.
2) Unplug and remove any cables and/or other
component connectors from the rear of theTV.
3) Remove the screws ofthe VESA Mounting Pattern
shown inthe table below, ifapplicable.
CAUTION: Do not use the screws removed from
the back cover to attach the wall mount bracket to
the TV.
4) Always use the screws supplied or recommended by
the wall mount manufacturer.
5) Follow the instructions provided with your wall bracket.
Before proceeding, make sure the appropriate
bracket(s) are attached to the wall and the back of the
TV as described in the instructions provided with the
wall bracket.
6) After attaching the appropriate bracket(s) tothe wall
and the back ofthe TV, remove the pedestal stand
from theTV, as described in this instruction document.
7) VESA Mounting Pattern
TVSize HolePattern(HxV) ScrewSize
40" 200mm x 200mm M6
50" 400mm x 200mm M8