Filter
Top Products
initial Setup
When you first turn on or reset the TV, the [nitial
Setup window will appear.
1 [n the Menu Languagefield, wess 4 or _ to
select your preferred language.
2 Press 4 or _ to select Time Zone and set your
desired time zone with 4 or _ and press @.
3 Next, the Location setting window will appear.For
normal home use, press 4 or _ to select Rome
and press @_.
4 Next, ART/CABLEin setup window will appear.
Press 4 or _ to select the input source (CaNe or
Antenna) for the ART/CABLEinput on the TV.
5 [f you select Antenna,the ChannelTuningNode
setup window will appear. To tune only digital
channels, select Digital To tune digital channels
preferentially over analog when entering channel
number directly, select Anto. For normal tuning,
selectStandard.Press @ to continue to Auto
Tuning.
B Press @ to select Start Scan and continue with
the Auto Tuning.
You can stop the Initial Setup with E_T.However if
you do not finish the entire [nitial Setup process, the
[nitial Setup window will appear every time you turn
on the TV.
$elecUng the menulanguage
You can choose from three different languages
(English, French and Spanish) for the on-screen
display of menus and messages.
To select the menu language:
MENU
Press © and open the Preferences menu,
highlight [VlennLanguage.
Press "9 or _ to select your preferred menu
language.
EXIT
Press O to close the Preferences menu.
Configuring the antenna input
source for the ART/CABLEterminal
To configure the ANT/CABLE input source:
MENU
1 Press © and open the Setup menu.
Highlight Jnsta]]ati0nand press _E_.
3 (A new set of Installation menu icons will appear,
as shown below.) Open the Terrestrialmenu,
highlight Inpnt Configuration,and press EN_._.
4 Highlight ART/CABLEin and press 4 or _" to
select the input source (Cableor Antenna)for the
ART/CABLEinput on the TV.
5 Tosave your new settings, highlight [}oneand press
@. To revert to your original settings, highlight
Canceland press @.
Programmingchannelsinto the
TV's channelmemory
When you press [_ or _ on the remote control
or TV control panel, your TV will stop only on the
channels you programmed into the TV's channel
memory.
Follow the steps below to program channels into the
TV's channel memory.
(conrin ued)
24