Filter
Top Products
ProgrammingchanneJsautomatically
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
No te:
o You must configure the ANT/CABLE input
source before programming channels (_:_
page 24).
o The automatic channelprogramming process
will erase channels that were previously
programmed into the TV'smemory,
o To tune the TVto a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
o Programming channels when the ANTi
CABLE input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless your
Cable TV service lineup changes significantly,
To program channels automatically:
] Configure the antenna input source, if you have
not already done so (_:_>page 24).
MENU
Press O and open the Setup menu.
3 Highlight Installati0nand press @.
5
The TV will automatically cycle through all the
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message "Scanning
channels, please wait" appears (as shown above).
EXIT
To cancel channel programming, press © on
the remote control (or highlight Canoe[ in the on-
screen display and press @).
When channel programming is finished, press
or L_J to view the programmed channels.
Setting channelskip
To prevent certain channels from being viewed,
channel positions can be skipped.
1 From the Setup menu, highlight installationand
press @.
2 Press A o1" Y to select ChannelOptionsand press
@. The list of channels will appear.
4 (A new set of InstaJJationmenu icons will appear,
as shown below.) Open the Terrestrial menu,
highlight ChannelProgramto bring up the Start
Scan, and press @ again to begin channel
programming.
3 Press & or V to select a channel position to be
skipped and press @. A tick will aF_pear in the
box.To remove the tick, press @ again.