Filter
Top Products
Viewingthe digital signal meter
You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
1 MENU
Press © and open the Setup menu.
2 Highlight Installationand press @.
3 A new set of Installation menu icons will appear.
Open the Terrestrialmenu, highlight Signal
Meter,and press @.
4. Press &V411_ to select the antenna input and
digital channel whose signal you want to check.
Note:
• The physical digital channel number fisted in
the Signal Meter screen may not correspond
to a virtual TV channel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
• The signal strength does not change between
virtual channels on the same physical
channel.
To close the screen and return to the
Terrestrial menu:
Highlight Doneand press Eft@.
To return to normal viewing:
EXIT
Press O.
Setting the time zone
The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information (_> page 51 ).
To set the time zone:
1 From the Setupmenu, highlight Installationand
press @. A new set of Installation menu icons
will appear.
Highlight TimeZone, and press @.
Press 4 or _ to select the region, highlight Done,
and then press @.
After the time zone has been set, you will be asked to
set the current Daylight Saving Time status.
To set the Daylight Saving Time status:
1 Press 4 or _ to select Yesor No, highlight Done,
and then press @.
Viewing the systemstatus
To view the system status:
MENU
1 Press 0 and open the Setup menu,
Highlight Installation and press @.
A new set of installation menu icons will appear,
Open the System Status menu, highlight System
Information,and press @.
4. Dess _ll_ to scroll through the menu bar to select
the FactoryDefaults or Support Information and
view the related information.
To close the screen and return to the
Installation menu:
Highlight Done and press @.
To return to normal viewing:
EXIT
Press O.
Reset FactoryDefaults
To reset all settings and channels to their
factory default values:
MENU
1 Press 0 and open the Setup menu.
Highlight Installationand press @. A new set of
installation menu icons will appear.
3 Open the System Status menu, highlight System
Information, and press @.
4. Dess 411_ to scroll through the menu bar to select
Factory Defaults.
5 Highlight Yesand press @.
6 (If PIN co& has been set, enter your PIN ccxte.Press
4 or _ to select Done and press @.) A warning
message will appear, select YeSand press @, the TV
will turn off automatically after a few seconds. After
the TV turns off, unplug the TV power coM and then
plug it in again to complete the reset prcvess.
To cancel the reset:
Select NOand press @ in step 5 above.
28