Filter
Top Products
17
Chapter 2: Connecting your TV
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 42/50HPX95 *web 213:276
S-VIDEO
OUT
VIDEO
OUT
AUDIO
OUT
COMPONENT VIDEO
L
R
L
R
Satellite
IN
P
B
P
R
Y
IN from ANT
VIDEO AUDIO
OUT to TV
CH 3
LR
LR
CH 4
IN
OUT
OUT
OUT
IN
Signal splitter
Connecting a VCR and satellite receiver
You will need:
one signal splitter
four coaxial cables
one set of component video cables (if your satellite receiver
does not have component video, connect the standard A/V
cables only)
one pair of standard audio cables
three sets of standard A/V cables
• For better picture performance, if your satellite receiver and VCR
have S-video, connect S-video cables (plus the audio cables)
instead of the standard video cables. Do not connect both types of
video cables to VIDEO 1 (or VIDEO 2) at the same time or the
picture performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV (VIDEO 1)
to your VCR’s audio out terminal using the white audio cable only.
To view satellite programs using the component video
connections:
Select the ColorStream HD-1 video input source on the
TV.*
To view satellite programs using the standard
video connections or to record satellite programs:
Turn on all three devices. Set the VCR to the appropriate
line input (refer to your VCR owner’s manual for details).
Select the VIDEO 2 video input source on the TV.*
To view the VCR or view and record antenna channels:
Turn ON the VCR. Tune the VCR to the channel you want
to watch. Select the VIDEO 1 video input source on the
TV.*
_____________
* To select the video input source, press INPUT on the remote control
(see page 72). To program the TV remote control to operate other
devices, see Chapter 3.
From antenna
From satellite dish
Satellite receiver
Stereo VCR
To use the TV Guide On Screen
™
recording features:
1. Connect the G-LINK
™
cable according to the
instructions on page 28.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your
VCR owner’s manual for details), and then turn OFF the
VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen
™
system.
5. See Chapter 7 for details on using the TV Guide
On Screen
™
system.
Note: The TV Guide On Screen™ system does not receive program
listings from or for any satellite service.
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1,
ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the appropriate
input mode is selected.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
TV back panel
#01E_014-030_4250HPX95 05.9.12, 10:17 PM17
Black