Filter
Top Products
27
Chapter 4: Initial Setup and Menu
7 Start Scan
Note: If you want to stop scanning, press O while
scanning.
•
After scanning completes, a channel list screen
(such as the one below) appears.
If channels are not found after scanning:
•Check the antenna/cable connections, and scan again.
•Connect the TV to the antenna or cable box directly
and scan again.
1 Y > SETUP > Quick Setup > .
2 A confirmation message appears. Press C or c to
select Yes. Press .
3 Set up to step 6.
•If you selected Antenna in the previous setting,
select Cable.
•If you selected Cable in the previous setting,
select Antenna.
4 Scan again.
•Refer to information on www.tacp.toshiba.com/
customersupport.
Navigating the menu system
•To open the main menu, press Y on the remote
control or TV control panel.
•Press B, b, C or c on the remote control or TV control
panel to navigate and make selections.
•To select a menu option, press . To return to the
previous menu page, press .
•To close a menu instantly, press Y or O.
•All menus will close automatically if you do not make
a selection within 60 seconds.
Previous settings will be lost! Press EXIT for
no change.
Start Scan
Auto Tuning
Press .
OK
DTV
ATV
ATV
ATV
ATV
ATV
DTV
ATV
Antenna Channels Found: 14
Auto Tuning (Antenna)
Ch. Type RF Ch.
2
4-1
4-2
6
11
13
18
31
2
4
4
6
11
13
18
31
OK
OK
SOUND
MTS
Balance
Advanced Sound Settings
Dolby Volume
Dynamic Range Control
Off
Low
Stereo
0
OK
WX800U_EN.pdf 27 2010/08/11 10:14:51