Filter
Top Products
Antenna Hookup
PAGE 11
RJP
INTERFACE
REMOTE
IN
AUDIO IN AUDIO OUT
AUX
CONTROL
DIGITAL
VIDEO OUT
DIGITAL
VIDEO IN
12
RJP
INTERFACE
REMOTE
IN
AUDIO IN AUDIO OUT
AUX
CONTROL
DIGITAL
VIDEO OUT
DIGITAL
VIDEO IN
12
RJP
INTERFACE
REMOTE
IN
AUDIO IN AUDIO OUT RS-232C
DISPLAY
CONTROL
AUX
CONTROL
DIGITAL
VIDEO OUT
AC IN
DIGITAL AUDIO
OUT (OPTICAL)
AC OUT
DIGITAL
VIDEO IN
MAX 8A 960W AC 120V~ 60Hz
12
1
2
3
RF Coaxial Wire
(75 ohm)
300/75 ohm
Adapter
Connections Panel
Connections Panel
Locate the Antenna/Cable jack on the back
of the HD Integrator Box System.
Connect the antenna wire (Flat or Round)
that runs from the wall to this jack,
according to one of the diagrams shown to
the right.
After all connections are complete, plug in
the TV. The HD Integrator Box System is
designed to operate on AC power.
Flat Wire
(300 ohm)
Connect an off-air antenna to the HD Integrator Box System.
If the antenna is a 75 ohm RF cable, then no
adapters are required.
A 300 to 75 ohm adapter is not included with
the Zenith HD Integrator Box System.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking
through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
300 TO 75 OHM
ADAPTER