Filter
Top Products
PAGE 52
Cloning Connections / Teaching Setup
Teaching the Master Setup to Another TV/STB
Connections for the LT2002 to Teach another TV/STB the Master Setup
Teach Master TV/STB’s Setup to the target
TV/STB
After learning is complete, remove the M.P.I. cable from the
master TV/STB and connect it to the target TV/STB that you
want to copy the master TV/STB’s setup into. With “THE CLONE
HAS CONTROL OF TV” message displayed, press 2 to go to the
“TEACH TO TV” option, press ON/OFF, POWER, or ENTER.
Select the LT2002 memory that the new setup is in. Press
On/Off to transfer the new setup and other information to the
new TV/STB. Teaching usually takes 2-3 minutes.
After the “TEACHING COMPLETE” message is displayed, press any
key to return to the Clone menu, then press ON/OFF, POWER, or
ENTER. If finished, detach M.P.I. cable from the target, newly
cloned TV/STB.
Disconnect TV/STB Power for 15 Seconds
Unplug the AC power cord of the newly cloned TV/STB from the
power outlet for about 15 seconds to activate the newly-copied
setup.
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
-TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
-TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER
TEACHING IN PROGRESS,
PLEASE WAIT
TEACHING COMPLETE
This menu should appear after any key is
pressed on the Installer remote.
This display will appear during Teaching
function.
This display will appear after Teaching is
complete.
RJP
INTERFACE
REMOTE
IN
AUDIO IN AUDIO OUT SERVICE
DISPLAY
CONTROL
AUX
CONTROL
DIGITAL
VIDEO OUT
AC IN 120V~60Hz
DIGITAL AUDIO
OUT (OPTICAL)
AC OUT 8A
DIGITAL
VIDEO IN
12
QuickSet II Programmer
LT2002
¤
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
. . . . . . . .
. . . . . . . .
. . . . . . . .
Ferrite Core
(TDK, ZCAT
2035-0930)
3.5mm Stereo Plug
with IR Receiver
DVI
RF Coaxial Wire
(75ohm)
Antenna
Wall Jack
AC Power
Cord