Filter
Top Products
PAGE 58
Installer Menu
094 - SAP MENU EN (2nd Audio Program)
Set to 1 to enable SAP feature, if available.
Set to 0 to disable SAP feature.
096 - DEF. ASP. RATIO (Default Aspect Ratio)
Selects default aspect ratio at power up, see settings below.
102 - ATSC BAND
Sets up TV to receive different types of incoming signals:
0=Broadcast, 1=CATV, 2=HRC, 3=IRC, 4=Same as NTSC.
103 - ATSC TUNE MODE
Selects ATSC tuning mode: 0=Virtual, 1=Physical.
Note: The setting above is ignored if Installer item 102 ATSC BAND,
is set to 1=CATV, 2=HRC, or 3=IRC. Then 103 - ATSC TUNE MODE
above always resets itself to Physical (1), regardless of what value
appears for item 103 on the Installer menu.
104 - START MINOR CHANNEL
Sets XX-XX minor starting channel at power up: 0=NTSC. If not 0,
number
selected is the Minor start channel number.
105 - VID OUT FORMAT
0=1080i 1=720p 2=480p
106 - ASP RATIO LOCK (Aspect Ratio Lock)
Set to 1 to retain previous aspect ratio with power Off.
Set to 0 to retain default aspect ratio with power Off. See item 96
Default Aspect Ratio above.
107 - BANNER SELECT
Not applicable.
108 - PANEL COM (Newer display panels set at 2)
Sets the panel baud rate.
110 - PANEL DELAY (Newer display panels set at 8)
Sets the panel delay time.
111 - PANEL VOL PRE
Preset panel volume to achieve the same volume levels as other
systems.
112 - PANEL STRT VOL
Panel start volume when on Aux. input.
113 - PANEL TYPE (Newer display panels set at 2)
Select the Panel Type according to the table which is part of a quick
setup guide that keeps on changing as new displays become
available.
114 - PANEL MIN VOL
115 - PANEL MAX VOL
Both items above sets the min/max volume of the display panel
when using other panel aux inputs aside from the one that the STB
uses. It is similar to the Min/Max Volume for the STB (items 8 & 9).
Item 8 & 9 limits the volume coming out of the STB while items
114 & 115 limits the Panel Volume.
116 - VIDEO MUTE EN (Video Mute Enable)
Set to 0 for normal.
Set to 1 for blank.
117 - FACT DEFAULT (Factory Default)
Set to 0 for normal.
Set to 1 to load default settings for all installer menu items.
WARNING: Setting this to 1 will reload the factory
defaults and clear the channel list including erasing any
assigned Channel Icons and Labels.
Set to 0 for set by program.
Set to 1 for 4:3.
Set to 2 for 16:9 (Factory Default).
Set to 4 for Zoom 1
Set to 5 for Zoom 2
(Continued from previous page)